HF/VHF/UHF-Matrix MAS1266 From Novotronik
The matrix distributes 2 antenna signals to 16 receivers in the frequency range 0.1 … 3000 MHz without any blocking.
.

Design

The matrix is housed in a 3 RU 19“ subrack which provides excellent RF shielding and consists of the following sub-assemblies:

–    low noise amplifiers with high dynamic range
–    power dividers 16-way
–    solid-state switches SPDT
–    processorboard
–    LAN interface
–    manual control module (optional)

All the necessary signal, power supply and earthing connections are provided at the rear.
The mains switch is located on the front panel.

Control

The matrix is normally controlled via a LAN interface.
Other control interfaces like RS-232, RS-422, RS-485 and IEEE488 are possible:

Special features

In order to improve operational safety the unit can be equipped with redundant power supply units and voltage monitoring boards.
The power supply voltages and the I/O boards are monitored in a processor routine.
The selected crosspoints as well as the voltage and I/O fault messages are displayed on the manual control module.
A status string can also be requested at any time via the control interface.
The unit is constructed using a modular approach utilising 19” plug-in sub-assemblies which enable ease of installation and maintenance.

Contact TINEX AS for more information on Sales@tinex.no or +47 481 96 666

Print as PDF

Technical data measured at 25 °C
Configuration: 2 inputs 16 outputs
non-blocking
RF specifications
Impedance: 50 Ohm
Frequency range: 0.1 … 3000 MHz
Gain: 1 +/- 1.5 dB
Gain flatness: +/- 1.5 dB typ.
Noise figure: 13.0 dB max.
Intercept point:
3rd order + 10 dBm min.
2nd order + 10 dBm min.
VSWR: 2.0 :1 max.
Isolation:
Out/out 40 dB min.
On/off 50 dB min.
Signal level: 0 dBm max.
Switching elements: solid-state switches
Further specifications
Control: LAN or tbd.
Manual control (optional): LCD (4×20) and pushbuttons (3×6)
RF connectors: N female
Power supply: 115 / 230 VAC, 47 … 63 Hz
Connector 3-pin, with mains filter and fuses
Mains switch: with integrated lamp
Temperature range:
Operating 0 … 50 °C
EMC: in accordance with European standard EN 61000-6-1 and EN 61000-6-3
Dimensions:
Height 3 RU
Width 19“
Depth about 480 mm (without connectors)
Front panel: painted light grey (RAL 7032)
Back